How Condom Catheter Works


Below is our guide to use our condom catheter and how it works. Our condom catheter is designed to be non-irritant, which is why it is made out of 100 percent silicone and has gelstrips. 

 

First Remove both plastic liners from the GelStrip™ adhesive gel and place the GelStrip™ on the surface of the penis behind the glans. While applying a slight tension to the GelStrip™, wrap it completely around the outside of the penis. Overlap the GelStrip™ and press it into place around the penis – DO NOT CUT!

NOTE: Application Method  Differs With The Non-Circumcised Male for our condom catheter gelstrips. The Foreskin Must First Be Pulled Forward Over The Glans Of the Penis Before The GelStrip™ Is Wrapped Around The Penis Behind The Glans!











2.Place the head of the penis into open end of condom catheter. Unroll the condom catheter onto the penis, over, and all the way across the GelStrip™ until the rolled end of the external condom catheter is behind the edge of the GelStrip™ nearest your body. Squeeze the condom around the circumference of the GelStrip™ to insure complete contact and a good seal.











3. Remove the protective liner from the SecureStrip™. Center the tape on the outside GelStrip™ “Bump” surface of the condom over the GelStrip™ “Bump.” While applying a slight tension to the tape, wrap it completely around the outside of the condom – DO NOT CUT! This is one of the most common errors in application. Slight tension must be applied with the SecureStrip to ensure the device will stay on effectively.

CAUTION: Do not wrap so tight as to restrict the flow of urine or blood.